Is programming the technology easy?

Echoflex’s products are a combination of unique transmitters and controllers/receivers that

need to be learned to each other. The intelligence of the solutions are in

the controller/receiver, while the transmitter’s send data turn off or on, temperature,

Light level, humidity etc.

The process for learning a switch to a controller/receiver takes seconds

TO PROGRAM THE SWITCH TO THE CONTROLLER, PLEASE FOLLOW THESE DIRECTIONS;

INSTALL THE CONTROLLER AS PER THE TECHNICAL INSTRUCTIONS INCLUDED.

USING A PEN HOLD THE CLEAR BUTTON DOWN UNTIL THE UNIT STARTS TO CYCLE. YOU SHOULD

BE ABLE TO HEAR THE RELAY.PUSH THE SWITCH ON SO THAT THE CONTROLLER RECEIVES THE

SIGNAL. THE CONTROLLER WILL ENGAGE IN THE ON POSITION.

WAIT UNTIL THE UNIT BEGINS CYCLING AGAIN. DO NOT ACTIVATE THE TRANSMITTER AGAIN

THIS WILL UNLEARN THE TRANSMITTER.

REPEAT 3 AND 4 UP TO 30 TIMES OR PRESS LEARN TO STOP THE LEARN PROCESS.

THE CONTROLLER AND SWITCH(S) SHOULD NOW BE PROGRAMED TO EACH OTHER.

TO PROGRAM ADDITIONAL SWITCHES PUSH THE LEARN BUTTON UNTIL THE UNIT

STARTS TO CYCLE AND GO BACK TO #3. (EACH CONTROLLER CAN LEARN UP TO

30 SWITCHES).

TO UNLEARN A SWITCH, PUSH THE LEARN BUTTON AND ONCE THE UNITS STARTS

CYCLING, PRESS THE SWITCH AND WAIT. ONCE BACK INTO CYCLING MODE PRESS

LEARN AGAIN TO STOP PROCESS. THE SWITCH SHOULD NOW BE UNLEARNED BY THE CONTROLLER.

THESE INSTRUCTIONS ARE ALSO PRINTED ON THE SIDE OF THE CONTROL UNIT.